When replacement of parts during repair work is needed, be sure to use SUBARU genuine parts. … Do not overtighten it as this may dama ge wheel bearing. 6 …

This service manual has been prepared to provide SUBARU service personnel with the necessary information and data for the correct maintenance and repair of SUBARU vehicles. FRONT SUSPENSION, REAR SUSPENSION, WHEEL AND TIRE SYSTEM, DIFFERENTIALS, TRANSFER CASE, DRIVE SHAFT SYSTEM, ABS, ABS (DIAGNOSTICS), BRAKE, PARKING BRAKE, POWER ASSISTED SYSTEM. 1. PROPELLER SHAFT. Propeller shaft type Front propeller shaft Joint-to-joint length: L 1 mm (in) Rear propeller shaft Joint-to-joint length: L 2 mm (in) Outside diameter of tube: mm (in). 1) Propeller shaft (Turbo model) 2) Propeller shaft (Non-Turbo model) (3) Rear differential (VA-type) (4) Rear differential (T-type) (5) Bush. 2. FRONT AXLE. (1) Baffle plate (SFJ) (2) Spring pin (3) Outer race (SFJ) (9) Boot (SFJ) (10) Boot (EBJ) (18) Oil seal (OUT) (11) EBJ ASSY (19) Hub bolt (4) Snap ring (12) Tone wheel (With ABS) (20) Hub (5) Trunnion (13) Baffle plate (21) Axle nut (6) Free ring (14) Oil seal (IN) (7) Circlip (15) Snap ring (8) Boot band (16) Bearing (17) Housing. 3. REAR AXLE.  AWD Model. (1) Circlip (12) Non-Turbo: BJ ASSY Turbo: EBJ ASSY (22) Hub (2) Baffle plate (DOJ) (23) Axle nut (3) Outer race (DOJ) (13) Baffle plate  (4) Snap ring (14) Oil seal (IN. No. 2) (5) Inner race (15) Oil seal (IN. No. 3) (6) Ball (16) Housing (7) Cage (17) Bearing (8) Circlip (18) Snap ring (9) Boot band (19) Oil seal (OUT) (10) Boot (DOJ) (20) Tone wheel (With ABS) (11) Boot  (21) Hub bolt. FWD Model. (1) Hub cap (5) Hub unit (2) O-ring (6) Hub bolt (3) Axle nut (7) Tone wheel (With ABS) (4) Washer (8) Spindle. CAUTION: •Wear working clothing, including a cap, protective goggles, and protective shoes during opera- tion. •Remove contamination including dirt and corrosion before removal, installation or disassembly. •Keep the disassembled parts in order and protect them from dust or dirt. •Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly, and replacement. •Be careful not to burn your hands, because each part on the vehicle is hot after running. •Use SUBARU genuine grease etc. or the equivalent. Do not mix grease etc. with that of another grade or from other manufacturers. •Be sure to tighten fasteners including bolts and nuts to the specified torque. •Place shop jacks or safety stands at the specified points. • Apply grease onto sliding or revolution surfaces before installation. •Before installing O-rings or snap rings, apply sufficient amount of grease to avoid damage and de- formation. •Before securing a part on a vice, place cushioning material such as wood blocks, aluminum plate, or shop cloth between the part and the vice…

Download 2001 IMPREZA SERVICE MANUAL