Notice of Copyright Duracell® PowerSource 1800 Owner’s Guide © 2007 Duracell. … and covers defects in workmanship and materials in your Duracell® PowerSource 1800…

Feature Description. 1 Fault LED illuminates red when PowerSource 1800 has an operation fault. 2 Power button turns PowerSource 1800 on and off when utility power is not available. •Pressing and holding the Power button for at least half a second turns the unit on or off when utility power is not present. •When utility power is available, the Power button cannot be used to remove power from any or all of the five AC outlets 3 AC Power/Battery LED illuminates green when utility power is available and flashes amber when PowerSource 1800 is running off its internal battery to provide backup power. 4 LED Screen indicates charging status, power draw from the PowerSource 1800 (W) when providing backup power, or battery capacity (%). The screen also shows error codes to aid troubleshooting. 5 Select Button displays PowerSource 1800 Battery Level (%) or Output Power (W). 6 Charged/Charging LED (green) illuminates when PowerSource 1800 is fully recharged and flashes while PowerSource 1800 is recharging. 7 AC Power Cord 8 Blue LED illuminates the rear AC outlets when AC power is available. 9 15 A supplementary protector protects the PowerSource 1800 AC outlets and your applications from overload conditions. 10 Five 120V AC outlets (One in the front, four in the rear) for powering office equipment and household appliances that draw a maximum total of 1800 watts (1440 watts continuous). All outlets are surge protected and backed up by the PowerSource 1800 internal battery. Installation and Operation. WARNING: Shock Hazard If the input plug is connected and utility power is present, the outlets will be energized. The front panel ON/OFF button will not turn these outlets off. Important: PowerSource 1800 should be used or stored in a clean, temperature- controlled, indoor area away from direct sunlight, moisture or conductive contaminants. Allow a minimum of 3 inches of space around the unit for optimal ventilation. Important: PowerSource 1800 must be charged immediately before storage or use. This will protect the battery inside from damage and will ensure extended usage run time. A complete charge may take up to 15 hours when recharged from a 120VAC wall outlet. CAUTION: Equipment Damage •Do not plug surge-protected power bars into the unit ’s 120VAC outlets. •Do not connect an AC power source to the 120VAC outlets. •Do not connect the unit’s AC power cord to its 120VAC outlets. To install PowerSource 1800: 1. Plug the power cord directly into a wall outlet (not into a surge protector or power strip). 2. Connect your electronic devices or small household appliances to the five AC outlets of the PowerSource 1800. 3. Turn on the unit by pressing the Power button for at least half a second. The green AC Power LED confirms that the PowerSource 1800 is on and ready to provide backup power. When the battery needs recharging, the LED screen flashes “CHG” 10 times, then the battery capacity (%) once. This pattern of flashing continues until the battery capacity reaches 100% and “FUL” appears on the screen…

Source: http://www.backuppower.citymax.com/

Download Duracell PowerSource 1800 Owners Guide