Thank you for purchasing a genuine Mazda accessory. … Be careful not to lose removed parts, and be sure that they are kept free from scratches, …

PARTS. Note: • Verify that the kit includes all the following parts and that they are free of dirt, scratches, or damage.• The actual part number is QSEA 34 700, however, the part number indicated on the accessory is QSE1 34 700. This does not indicate a port shipment mistake. REQUIRED TOOLS. Prepare the following tools or items before installation. Wrench, 49 T028 3A0 (Special service tool) , 49 T034 1A0 (Special service tool), 49 T034 101 (Special service tool), 49 T034 105 (Special service tool), 49 0107 680A (Special service tool),  49 T034 102 (Special service tool), 49 T034 103 (Special service tool), 49 T034 104 (Special service tool), Clean rag. Battery removal: 1. Remove the engine cover. 2. Remove the hose from the battery cover. 3. Lift up the rear of the battery cover and remove. 4. Disconnect the negative battery cable. WARNING. • Never place the battery near an open flame. Flammable gas from the battery can be ignited resulting in an explosion. 3. VEHICLE PARTS REMOVAL. CAUTION. • Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the  following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled while the installation work is performed. 1. Remove the front suspension tower bar and then the plates. 2. Remove parts [1] to [16] in the order indicated in the figure. Front upper arm ball joint removal 1) Remove the front upper arm ball joint from the steering knuckle using the special service tool, 49 T028 3A0. Piston rod nut removal. WARNING. • Before removing the piston rod nut, secure the shock absorber and spring in the special tools. Otherwise, the shock absorber and spring could fly off under tremendous pressure and cause serious injury or death, or damage to vehicle parts. 1) Protect the coil spring from scratches using a clean rag, and install the special service tools. 2) Compress the coil spring using the special service tools, and remove the piston rod nut…

Download GENUINE FRONT SHOCK ABSORBER