Installation Instructions: 1. Pull vehicle into service bay and access center console. 2. Disconnect both battery terminals. These cables must be disconnected during installation to …

Installation Instructions: 1. Pull vehicle into service bay and access center console. 2. Disconnect both battery terminals. These cables must be disconnected during installation to insure proper initialization of the DICE module when it is connected. Make sure you have the vehicle’s radio security code before disconnecting the battery cables! Detailed steps for removing the Honda/Acura radio can be found in your factory manual this supplement will ONLYshow an outline for radio removal. 3. Twist the shift knob off by rotating it counterclockwise. Remove the trim plate covering the Gear Selector which is held in place by plastic clips. Disconnect the seat heater control wiring. 4. Remove the front coin storage tray and power adapter. 5. Remove the phillips screws holding the plastic trim and radio mount in place. Carefully pull the assembly away from the dash. The entire console will pull out along with the radio. 6. Locate the CD Changer wiring harness; this will be on the back of the radio. The DICE vehicle Interface Cable will need to connect to this port. Its recommended to install your DICE module in a easily accessable location or to extend theAUX connector for future connections of auxiliary devices. 5. Remove the phillips screws holding the plastic trim and radio mount in place. Carefully pull the assembly away from the dash. The entire console will pull out along with the radio. 7. Connect the vehicle specific cable’s 8-pin molex connector and iPod Docking Cable to the DICE module. The correct plugs on the DICE module can be identified by matching it up with the connector or by looking for the label on the bottom of the module. This will be a good time to test your installation. Before reinstalling your radio, connect your iPod and test for audio, and controls from the radio. If everything is ok, proceed to the next step. 9. Verify all connections and re-install the radio into the vehicle by sliding it into the…

Source: http://www.autotoys.com/

Download Installation Supplement for Mazda