End Wrench www.endwrench.co m The Subaru Wheel Bearing Replacement Subaru Wheel Bearing Replacement Subaru Wheel Bearing Replacement End Wrench www.endwrench.co m The 10 Ongoing studies of vehicle …

Make sure the groove is outward. Place the OTC 314308 with a washer onto the puller bolt. This will be placed into the bearing housing. Apply the included special grease to the puller bolt, once during disassembly and again during reassembly. Carefully thrust the slide outward until the wheel bearing hub is removed. Remove the snap ring. Remove the inner seals from the bearing housing. The OTC 311887 with washer and nut will be placed onto the opposite end of the puller bolt after it has been inserted into the bearing housing. If the wrong side of OTC 311887 is placed against the bearing the tool will become jammed into the inner race. Place OTC 311882 over the bearing housing. The groove must face out- ward. Rotate the OTC 311882 as it is installed and make sure it is making full contact with the backing plate. Place the OTC 311883 into the OTC 311882. Position the tools for bearing removal. Secure a wrench on the nut located on the backside of the bearing hous ing. Using a breaker bar, begin tightening the puller bolt. Switch to the air ratchet after the initial tension of the bearing has been overcome. Install a set of press plates below the old inner race and remove with appropriate press and press tools. Reinstall the tone wheel (5.4 ft-lb) if equipped. Insert the puller bolt with washer into the hub. Place the J45697-1 with the smaller diameter surface facing inward onto the puller bolt after it has been inserted through the bearing housing. The slot will be used to insert a depth gauge. Secure a wrench on the nut and begin tightening the puller bolt with the air ratchet. Finish the installation with the breaker bar. Thread seal installer J45697-11 with the smaller diameter facing outward onto driver handle J8092. Install the outer seal. Remove all tools from the puller bolt. Push out the bearing stay from the center of the installed bearing using the head of the bolt. Prepare the hub for installation. Remove the old outer seal from the hub. Remove the tone wheel if equipped…

Download Subaru Wheel Bearing Replacement