FOREWORD This Supplementary Service Manual has been prepared to introduce new service and data for the XVS650AN(C). For complete service information procedures it is necessary to use …

EXPLODED DIAGRAMS To help identify parts and clarify procedure steps, there are exploded diagrams at the start of each removal and disassembly section. 1. An easy-to-see exploded diagram 4 is provided for removal and disassembly jobs. 2. Numbers 5 are given in the order of the jobs in the exploded diagram. A number that is enclosed by a circle indicates a disassembly step. 3. An explanation of jobs and notes is presented in an easy-to-read way by the use of symbol marks 6. The meanings of the symbol marks are given on the next page. 4. A job instruction chart 7 accompanies the exploded diagram, providing the order of jobs, names of parts, notes in jobs, etc. 5. For jobs requiring more information, the step-by-step format supplements 8 are given in addition to the exploded diagram and the job instruction chart. CONTENTS: GENERAL INFORMATION, MOTORCYCLE IDENTIFICATION, VEHICLE IDENTIFICATION NUMBER, MODEL LABEL, SPECIFICATIONS, GENERAL SPECIFICATIONS, MAINTENANCE SPECIFICATIONS, ENGINE , CHASSIS, ELECTRICAL, LUBRICATION POINTS AND LUBRICANT TYPES, ENGINE, CABLE ROUTING, PERIODIC INSPECTION AND ADJUSTMENT, REAR BRAKE ADJUSTMENT, SHIFT PEDAL ADJUSTMENT, CARBURETION, AIR INDUCTION SYSTEM, AIR INDUCTION SYSTEM DIAGRAMS, CHECKING THE AIR INDUCTION SYSTEM, CHASSIS, FRONT BRAKE, FRONT BRAKE PADS, FRONT BRAKE CALIPER, WIRING DIAGRAM . CABLE ROUTING. A. Inside the motorcycle. B. Place the end of the plastic locking tie as shown. C. Fasten the rear brake switch lead, sidestand switch lead and rectifier/regulator lead with metal clamp or plastic locking tie. D. Pass the front flasher light leads (left and right) and headlight lead through the headlight cover hole. E. Pass the left handlebar switch lead behind the upper bracket. F. Fasten the left handlebar switch lead with a plastic locking tie. G. Pass the speedometer cable, speedometer light leads and fuel tank breather hose through the fuel tank hole. H. To the speedometer light leads. I. Rectifier/regulator lead should not be out over the bracket. J. Pass the right handlebar switch lead and headlight lead over the other harness and leads. K. Pass the clutch cable through the cable guide. L. Fasten the sidestand switch lead and rectifier/ regulator lead with a plastic locking tie. M. Install the plastic locking tie so that it is up against the frame projection. N. To the engine. O. Pass the sidestand switch and the lead wire through the sidestand bracket. When installing, wake sure not to have any extra loosening…

Source: http://www.stargis.net/

Download Yamaha XVS650AN(C) Supplementary Service Manual